3D spausdinamo tempimo jutiklio kūrimas ir tyrimas
Vėta, Mindaugas |
Recenzentas / Rewiewer | |
Recenzentas / Rewiewer | |
Darbo gynimo komisijos narys / Thesis Defence Board Member | |
Darbo gynimo komisijos narys / Thesis Defence Board Member |
Baigiamajame magistro darbe kuriamas bei tiriamas 3D spausdinamas tempimo jutiklis. Atlikta panašių tyrimų bei analoginių įrenginių apžvalga. Aprašyta jutiklio kūrimo eiga, ištirtos medžiagos charakteristikos atliekant jutiklio tempimo tyrimą. Tyrimas atliktas naudojant tempimo stendą, kuris leido tiksliai įvertinti deformacijos poveikį jutiklio atsakui. Apibendrinus gautus rezultatus, suformuotos darbo išvados, pateikiamos rekomendacijos tolimesniems tyrimams bei galimos pritaikymo sritys. Darbą sudaro: įvadas, analoginių įrenginių ir tyrimų apžvalga, 3D spausdinamo tempimo jutiklio metodologija, tyrimo eigos planas, įrangos analizė, jutiklio kūrimo eiga, tempimo tyrimas, rezultatai bei išvados. Darbo apimtis – 66 p. teksto, 46 paveikslai, 3 lentelės, 26 bibliografiniai šaltiniai.
The final master's thesis focuses on the development and investigation of a 3D-printed strain sensor. A review of similar studies and analog devices has been conducted. The process of developing the sensor is described, and the material properties have been examined through a tensile test of the sensor. The study was conducted using a tensile testing stand, which allowed for an accurate assessment of the deformations in the sensor response. After summarizing the results obtained, the conclusions of the work are presented, recommendations for further research and possible areas of application are provided. The thesis consists of: an introduction, a review of analogous devices and studies, the methodology of the 3D-printed strain sensor, the research plan, equipment analysis, the sensor fabrication process, tensile testing, results, and conclusions. The volume of the thesis is 66 pages of text, 46 figures, 3 tables, and 26 bibliographic sources.