Ni-Cr-B-Si perlydomų dangų tyrimas.
Medžiagotyros ir suvirinimo katedra |
Anotacija Baigiamajame magistro darbe nagrinėjamos užpurkštos ant aliuminio lydinio ir perlydytos Ni-Cr-B-Si dangos savybės. Aliuminis ir jo lydiniai dėl mažo tankio ir gerų mechaninių savybių plačiai naudojami įvairiose technikos srityse, kuriose gaminio masės mažinimas yra svarbus tikslas - aviacijoje, mašinų gamyboje ir pan. Tačiau šių lydinių taikymą labai riboja jų mažas atsparumas dilimui, kavitacijai, agresyviai terpei. Taigi aliuminį ir jo lydinius padengiant Ni-Cr-B-Si danga ir po to ją perlydant, būtų išvengiama paminėtų problemų. Darbe pateikta: dangų perlydymo metodų, terminio purškimo technologijų, dangos savybių tyrimų metodų bei skirtingų substrato paviršiaus paruošimo būdų apžvalga. Dangoms purški naudotas robotizuotas stendas „Mottoman”. Dangos perlydytos impulsiniu TIG būdu. Atlikti dangos mikrostruktūros, porėtumo, mikrokietumo, adhezijos tyrimai bei atliktas kaitinamo bandinio skaitinis šiluminių mainų modeliavimas. Suformuluotos darbo išvados. Darbą sudaro šešios dalys: įvadas, literatūros analizė, eksperimentiniai tyrimai, tyrimų rezultatai, išvados, literatūros sąrašas. Darbo apimtis - 70 p. teksto be priedų, 54 iliustr.,6 lent., 25 bibliografiniai šaltiniai.
Annotation The master thesis analyzes properties of Ni-Cr-B-Si coating sprayed on aluminum alloy and remelted. Aluminum and its alloys due to the low density and good mechanical properties are widely used in various technical fields, where the reduction of products weight is an important objective - aviation, mechanical engineering and so on. However, the application of these alloys is limited by their low resistance to abrasion, cavitation and aggressive environment. Therefore aluminum and its alloys coated by Ni-Cr-Si-B coating and afterwards remelted would allow to avoid these problems. Presented in the master thesis: methods of the remelting of the coatings, techniques of the thermal spray, research methods of the surface properties and review of different methods of substrate surface preparation. Coatings were done in the robotic spray booth. Coatings were remelted by pulsed TIG method. Were performed tests of the coating microstructure, porosity, microhardness, adhesion and heated sample was carried out numerical simulation of heat exchange by the ANSYS program. Formulated conclusions. Structure: introduction, review of literature, experimental researches, results of researches, conclusions, references. Thesis consists of 70 pages of text without appendixes, 54 pictures, 6 tables, 25 bibliographical entries.